Reverse Osmosis Water Station 5000 Series

This is normal and not a unit failure. In order to be safer when dispense hot water, the ambient/hot water is equipped with a water vapor separation device to prevent the vapor from scalding people. When the unit receives a water stop signal, the water vapor separation box cannot be filled with water and is connected to the atmosphere. When the water is flowing, all the water must flow out, so there will be a slight delay.

The capacity of the tank for tap water is 4L and for purified water is 1.2L.

The reverse osmosis filter for this dispenser is labeled ADD541.

4 water volume settings: 150, 200, 300 or 500 ml

The device size is (W x D x H): 200 x 334 x 404 mm

If you can't dispense water: 1. Check whether the water filtration indicator on the screen is flashing. If it means there is not enough water, you need to wait for a few minutes. When you see that the indicator is not flashing, you can dispense water. 2. Is there no water in the purified water jug and the raw water tank? (the water shortage indicator flashes red), if so, the water in the raw water tank must be replaced.

In order to ensure the quality and stability of the product and reduce the risk of use, our water stations will undergo a water test before shipment. After the test, there is a small amount of residual water in the internal pipes of the unit. After transportation, there is a small amount of water in the water outlet of the unit.

There are 4 temperatures to choose from: Ambient, 45°C, 85°C, 99°C.

In order to ensure the taste of the water, it is recommended to replace the filter element about every 12 months. However, the replacement time will vary depending on your local water quality and the water consumption of your home.

Yes, the unit is equipped with a boiling point self-adjusting function, which is suitable for different altitude areas. If your area is a plateau area, it is recommended that you follow the operation to adjust the boiling point before first use.

You need to flush out the protective fluid of the RO filter element and flush the waterway to ensure that the drinking water is safe enough and has no odour.

Long press “Ambient” + “150ml” for 3 seconds to reset the filter cartridge lifetime

Re-cleaning has no effect on the cleaning effect. Just follow the instruction manual and clean again next time. However, the unit will not memorize the previous cleaning steps and needs to start over again, so it is not recommended to interrupt the cleaning process.

The color of the filter lifetime indicator shows the remaining lifetime of the filter cartridge: Blue light: more than 10% lifetime left; Flashing red light: less than 10% lifetime left; Constant red light: the filter has reached the end of life and replace it now

The UV-C LED sterilizer in the filtered water tank starts working for 1 hour once the purified water tank is full. Automatic disinfection: The UV-C LED sterilizer in the purified water tank turns on for 10 minutes every 50 minutes.

Yes. When the inlet water temperature in the tap water tank in lower than 10°C, winter mode can be set to heat the water to 25°C. Long press the ambient button for 3 seconds, and press the water extraction button. This is valid for single extration only.

The drain water ratio of this unit is 3:1, that is, every 3 cups of filtered clean water will filter 1 cup of drain water, and the water filtration rate is as high as 75%, which is very water-saving.

Each Philips water purification equipment is specially matched with filter elements, and other brands of filter elements are not applicable.

This is an installation-free product. It can be easily plugged in and used. It can be used wherever needed in the living room/kitchen/study/bedroom. It's recommended to avoid placing it under direct sunlight to prevent the growth of microorganisms.

It is 1,2 meters. It's basically enough. If you want a wider range of use, you can prepare an extension socket.